This guide walks you through the installation of your EcoSmart Fire T-Lite fireplace. Follow each step carefully to ensure safe and correct setup.

Do not operate the appliance until it has been securely fastened using the included ground fixing brackets.

Equipment required: Long Philips head screw driver

Position the fireplace in accordance to the compulsory minimum clearances outlined on the Fireplace Clearances page.

These models come with Ground Fixing Brackets so they can be installed in a fixed position.

Installation Steps - T-Lite Series Designer Fireplaces 1

1. Confirm you have received all necessary parts as illustrated;

Installation Steps - T-Lite Series Designer Fireplaces 2

2. Tip base and Burner on its side and fix the three (3) Glass Support Brackets from underside using the philips head screw driver;

Installation Steps - T-Lite Series Designer Fireplaces 3

3. Ensure Glass Support Brackets are firm and tight and set base upright again;

Installation Steps - T-Lite Series Designer Fireplaces 4

4. For indoor use, insert burner into the model.

Installation Steps - T-Lite Series Designer Fireplaces 5

5. For outdoor use, remove the built-in tray from the base and replace with the Burner.

Installation Steps - T-Lite Series Designer Fireplaces 6

6. Carefully place the glass fire screen onto the three (3) metal brackets. Ensure bumpers are intact on the brackets to prevent damaging the glass fire screen.

Installation Steps - T-Lite Series Designer Fireplaces 7

7. Follow the instructions supplied with the Ground Fixing Brackets to complete the installation of the product.

Installation Steps - T-Lite Series Designer Fireplaces 8

Rubber feet are attached to the base of the model – ensure these remain in place and that the surface the fireplace is placed on does not reduce the clearances created by the feet, e.g shag carpet and table decorations.

Operate according to the Burner Operations Manual included with the burner.

Applies to:

  • T-Lite 3, T-Lite 8